01 Types of Chain Drives: Uses, Design, Application, Pros, and… • 02 The Hidden Pattern Behind Intermittent Dashboard Warnings • 03 How to Choose the Right Generator for Your Sump Pump • 04 Locked Out: Expert Tips to Rescue Your Car Keys Without Dam… • 05 C0035 - Left Front Wheel Speed Circuit Malfunction • 06 What Happens When the Throttle Body Gets Dirty • 07 The Reason Fault Codes Change After Driving For A While • 08 How to Prevent Car Damage from Long-Term Parking • 09 Fueling Your Journey: A Comprehensive Guide to the Fuel Sup… • 10 This Is Why Your Car’s CV Axle Is Failing •

DTC codes / U04xx · Invalid data received from a module / U0448

U0448Invalid Data Received from Gateway B

U0448 means the module that requested data from the central gateway received a message it could not validate, so the gateway's response was flagged as invalid. The gateway is the in-vehicle router that passes messages between networks, and this code tells you the receiving module saw corrupted, missing, or out-of-range data from Gateway B rather than a total loss of communication.

SystemNetwork
Code typeGeneric (all makes)
SeverityMedium
Fix difficultyProfessional
AreaInvalid data received from a module

Symptoms you may notice

  • Illumination of the malfunction indicator lamp (MIL) or a message on the driver information center
  • Multiple unrelated warning lights or system messages appearing at the same time
  • Intermittent operation of features that depend on cross-module data, such as stability control or driver-assist displays
  • A no-start or crank-no-start condition if the gateway feeds the module that authorizes starting
  • Often no symptoms besides the warning light, with the vehicle driving normally
  • Stored companion codes in several modules that all reference the gateway

Common causes, most likely first

  1. Corroded, loose, or damaged gateway connector pins or terminals
  2. A gateway module with failing internal circuitry or corrupted configuration
  3. Low battery voltage or a weak ground that drops the gateway offline momentarily
  4. A software or calibration mismatch after a module replacement or reprogramming event
  5. CAN (Controller Area Network) bus wiring damage or a shorted segment that corrupts gateway traffic
  6. A module on the network flooding the bus and causing the gateway to emit invalid data
  7. Water intrusion into the gateway or a connector in a location prone to moisture

How to diagnose and fix it

  1. Record all stored codes from every module before clearing anything, because companion codes point to the true source
  2. Check battery voltage and perform a load test, then inspect and clean the gateway ground connections
  3. Inspect the gateway connectors for corrosion, pushed pins, and water intrusion, and repair as needed
  4. Measure CAN bus resistance and check for shorts to ground or battery voltage on the bus segments
  5. Verify the gateway part number and calibration match the vehicle, and reprogram or configure if a mismatch is found
  6. Substitute a known-good gateway only after wiring and power checks pass, then perform any required relearn or configuration
  7. Clear codes and road test through several drive cycles to confirm the fault does not return

Why the gateway is rarely the real culprit

  • A gateway that reports invalid data is often reacting to a noisy or shorted bus, so replacing it first frequently leaves the code present.
  • Low voltage during cranking can drop the gateway offline long enough to set U0448 without leaving any other trace in the modules.
  • After a module replacement, a missing configuration or mismatched software level can make the gateway reject messages it previously accepted.
  • This code does not mean the gateway has failed completely; it means the data it sent failed a validity check, which can come from a single corrupted frame.
  • Companion codes in body, chassis, and powertrain modules often reveal which network segment is actually disturbed.

Can I keep driving with U0448?

The vehicle may drive normally, but because the gateway carries safety-related data, avoid long trips and any driving that depends on stability control or driver-assist features until the fault is diagnosed. If the engine will not start or multiple systems are disabled, have the vehicle towed rather than driven.

Tools that help

Tools we recommend are in the Auto Veteran shop on Amazon. As an Amazon Associate we earn from qualifying purchases.

Guidance is general and written for all OBD-II vehicles. Exact tests and values vary by model, so confirm the fault before replacing parts.

Running on fumes Free guides aren't free to make. Top up the tank. Any amount, one time. Fuel the Garage