01 Why Disconnecting Your Car Battery for Storage is a Good Ba… • 02 Spark Plug Change: Should You Also Replace Ignition Coils T… • 03 The $30 Device That's Making Car Thieves Invisible to Police • 04 This Is How Your Turbocharger Works And Why A Small Whistle… • 05 This Is How Wet Brakes Or A Wet Clutch Signal Urgent Mainte… • 06 What Is the Minimum Compression for an Engine to Run? • 07 B0051: Deployment Commanded • 08 Why Does Your Car Shake When Braking at High Speeds? • 09 Stellantis: The Birth of a New Automotive Star from FCA and… • 10 What Happens If You Don't Change the Oil in Your Car? •

DTC codes / P07xx · Transmission / P07E9

P07E9Transmission Range Control A Circuit Performance

P07E9 indicates that the transmission control module (TCM) has detected a performance fault in the 'A' range control circuit, which is responsible for confirming that the transmission is in the commanded range. The TCM monitors voltage or current on the circuit and sets this code when the signal does not match expected values for the current gear or range.

SystemPowertrain
Code typeGeneric (all makes)
SeverityMedium
Fix difficultyProfessional
AreaTransmission

Symptoms you may notice

  • Illumination of the check engine light or transmission warning light
  • Transmission may enter limp mode, limiting vehicle speed and gear selection
  • Harsh or delayed shifts, or failure to shift into certain gears
  • Inability to engage certain ranges, such as reverse or drive
  • Often no symptoms besides the warning light, especially if the fault is intermittent

Common causes, most likely first

  1. Faulty transmission range sensor or internal mode switch
  2. Damaged, chafed, or corroded wiring in the range control circuit
  3. Loose or contaminated electrical connector at the transmission
  4. Failed transmission control module (TCM) or internal circuit fault
  5. Mechanical issue inside the transmission, such as a stuck valve or actuator
  6. Low or contaminated transmission fluid affecting range sensor operation

How to diagnose and fix it

  1. Perform a visual inspection of the transmission wiring harness and connectors for damage or corrosion
  2. Check transmission fluid level and condition according to the manufacturer's procedure
  3. Use a scan tool to read live data and verify the range sensor signal in each gear position
  4. Test the range sensor circuit for continuity, voltage drops, and shorts using a multimeter
  5. Inspect and clean the transmission range sensor and its connector, then re-test
  6. If the sensor is faulty, replace it and clear the code to see if it returns
  7. If the code persists, diagnose the TCM and internal transmission components as per service information

Range circuit faults often misdiagnosed

  • A loose ground connection at the transmission can cause intermittent range circuit performance codes that mimic a failed sensor.
  • Aftermarket electrical accessories or poor previous repairs to the harness are common causes of this code that many technicians overlook.
  • The code can be set by a mechanical issue inside the transmission even when the electrical circuit tests perfectly, so do not replace the TCM without confirming the sensor signal.
  • On some vehicles, the range sensor is integrated into the transmission and not serviceable separately, requiring transmission removal for replacement.
  • Intermittent faults may only appear when the transmission is hot or after driving over rough roads, so a wiggle test of the harness while monitoring live data is essential.

Can I keep driving with P07E9?

If the vehicle drives normally and the light is steady, you can drive cautiously to a repair shop, but avoid heavy loads or aggressive driving. If the transmission is in limp mode or shifting erratically, stop driving and have the vehicle towed to prevent further damage.

Tools that help

Tools we recommend are in the Auto Veteran shop on Amazon. As an Amazon Associate we earn from qualifying purchases.

Guidance is general and written for all OBD-II vehicles. Exact tests and values vary by model, so confirm the fault before replacing parts.

Running on fumes Free guides aren't free to make. Top up the tank. Any amount, one time. Fuel the Garage